24 rivet heads to install 😉
I drill a 0.8mm hole to hold the liquid cement so that it would not overflow to the sides and create a mess.
Any other ways to do this cleanly?
could you drill a smaller hole in the very center – put in the rivet held on by take and then carefully wick some glue in from the bottom? Dont turn it upside down so the glue does not migrate oput the top? Maybe test something like this on a scrap piece?
could you drill a smaller hole in the very center – put in the rivet held on by take and then carefully wick some glue in from the bottom? Dont turn it upside down so the glue does not migrate oput the top? Maybe test something like this on a scrap piece?
held on by TAPE… sorry